Phone: 800.968.8878
Fax: 888.686.0880

5303 W. Vienna Road, Clio, MI 48420

 
Prices and Ordering









 

The Heat Swapper™ utilizes heat from your hot water heater or boiler to heat your swimming pool or spa -- with the same efficiency as the existing heat source. The Heat Swapper™ saves the expense of operating an additional heater for your spa or pool.

The hot water from the existing water heater or boiler is circulated through the stainless steel coil inside the Heat Swapper™. The spa or pool water is heated as it passes over the outside of the coil.



Better Than an Electric Heater

The Heat Swapper™ can save significantly in heating costs when connected to a natural gas heater.  It heats much faster than an electric heater and easily maintains the temperature even when the jets are running.  Also, the electric service in most homes do not have the capacity to handle the load of an electric heater without additional expensive wiring.  

Better Than a Gas Heater

The Heat Swapper™ eliminates the need to run an additional gas line and exhaust flue for a spa or pool heater.  It has no gas valve and no pilot to waste fuel and is much smaller than a gas heater.

Most gas heaters have copper heat exchangers which are subject to damage from low pH or chemical imbalances.  The Heat Swapper’s™ stainless steel heat exchanger is much more tolerant of these common water problems.  Our thermostat is twice as accurate as those on most heaters and the standard Balboa remote digital display can be located conveniently for temperature adjustments.

Sizing

With 140° heat source, one Heat Swapper™ will heat a 500 gallon spa.  With 190° heat source, one Heat Swapper™ will heat a 1000 gallon spa, a 20 x 40 indoor pool, or 16 x 32 outdoor pool.  These are general guidelines.  Call us for sizing information for your specific application.






All images and content © 2007 Quality Pool Manufacturing